- N +

Quick Clamps (Vertical Clamp with Horizontal Base, without Clamping Bolts)

Quick Clamps (Vertical Clamp with Horizontal Base, without Clamping Bolts)

Vertical Clamp Version A Size 530 SKU: 67602500
垂直夹紧器 A 型号,尺寸 530,SKU 编号:67602500。


Material: Steel-sheet parts: Case-hardened steel C10, zinc-plated. Bearing pins: Hardened, from size 200 case hardened.
材料:钢板部件:硬化钢C10,镀锌。轴承销:硬化处理,200号以上尺寸硬化钢。


All moving parts lubricated with special grease. Handle with plastic sleeve, red, oil resistant. Operating handle and clamping lever move in the same direction. In the clamping position the operating handle is vertical. Vertical clamps are available for holding forces FH from 90 daN up to 460 daN. Note: Worth pointing out is the clamping arm on all vertical clamps: It is blanked out from full and reinforced on the points of highest load. During the closing movement it is guided on both sides to prevent being affected by possible side thrusts. Version A: forked clamping arm. Version E: solid clamping arm. Attention: The clamping bolts and protective cap have to be ordered sperately.

所有移动部件使用特殊润滑脂润滑。手柄带有塑料套,红色,耐油。操作手柄和夹紧杆向同一方向移动。在夹紧位置,操作手柄是垂直的。垂直夹紧器可用于保持90 daN至460 daN的保持力。注意:所有垂直夹紧器上值得注意的是夹紧臂:它从完整的状态下冲压而出,并在受力最大的点上加强。在关闭运动期间,它在两侧被引导以防止受到可能的侧向冲击的影响。A型:叉形夹紧臂。E型:实心夹紧臂。注意:夹紧螺栓和保护盖必须单独订购。


* Clamping bolt has to be ordered separately.
*夹紧螺栓必须单独订购。


Maedler Product No. Version M

676 102 00

676 103 00

676 105 00

676 111 00

676 117 00

676 122 00

 

Maedler Product No. Version O

676 143 00

676 145 00

676 151 00

676 157 00

676 162 00









返回列表
上一篇:
下一篇:
免责声明